MREL and TLAC explained
TLAC (total loss-absorbing capacity) is the Financial Stability Board's standard for global systemically important banks: at least 16% of risk-weighted assets and 6% of the leverage ratio denominator from 1 January 2019, rising to 18% and 6.75% from 1 January 2022. MREL (minimum requirement for own funds and eligible liabilities) is the UK's requirement, set by the Bank of England as resolution authority, and for UK G-SIBs it follows TLAC.
- TLAC (FSB)
- UK MREL (Bank of England)
- Arithmetic illustrations
- MREL compared with capital ratios
- Not stated
- Sources
TLAC: the FSB term sheet
The FSB's term sheet of 9 November 2015, section 4, calibrates minimum TLAC as follows:
| Measure | From 1 January 2019 | From 1 January 2022 |
|---|---|---|
| Share of the resolution group's risk-weighted assets (TLAC RWA minimum) | at least 16% | at least 18% |
| Share of the Basel III leverage ratio denominator (TLAC LRE minimum) | at least 6% | at least 6.75% |
The term sheet says the RWA requirement does not include any applicable Basel III capital buffers, which must be met in addition. The term sheet also says capital that counts towards minimum regulatory capital may also count towards Minimum TLAC, subject to conditions, one of which is that CET1 used to meet Minimum TLAC must not also be used to meet regulatory capital buffers.
UK MREL: the Bank of England statement of policy
The Bank of England's statement of policy, effective from 1 January 2026, says the Bank expects to direct UK resolution entities that are bail-in institutions to comply with the following end-state external MREL (para 4.11):
| Institution type | End-state external MREL: the higher of |
|---|---|
| G-SIBs | (i) two times the sum of Pillar 1 and Pillar 2A; (ii) the higher of two times the applicable leverage ratio requirement or 6.75% of leverage exposures (in line with the FSB's TLAC standard); or (iii) 18% of risk-weighted assets (in line with the FSB's TLAC standard) |
| D-SIBs and any other UK bail-in resolution entities | (i) two times the sum of Pillar 1 and Pillar 2A; or (ii) if subject to a leverage ratio requirement, two times the applicable requirement, i.e. 6.5% if the leverage ratio is 3.25% |
The statement of policy also describes interim and transitional steps. For example, it says indicative MRELs during the transition are expected to be set by a three-step or two-step approach, ending at 2 x MCR (para 9.8). It defines minimum capital requirements (MCR) by reference to the PRA Rulebook own funds requirement or, if higher, the minimum leverage ratio. Resolution strategy matters: the calibration above applies to institutions for which bail-in is the preferred resolution strategy (para 4.11).
Arithmetic illustrations (invented numbers)
FSB TLAC for a hypothetical G-SIB. RWA of 1,000 and a leverage ratio denominator of 3,000. From 1 January 2022: 18% of RWA is 180; 6.75% of 3,000 is 202.5. Because both minimums apply, the higher figure, 202.5, is the one that binds.
UK MREL for a hypothetical D-SIB. Pillar 1 of 8% and Pillar 2A of 2% of RWA, on RWA of 1,000. Two times the sum is 2 x (80 + 20) = 200. If the bank is subject to a 3.25% leverage ratio on exposures of 4,000, two times the requirement is 6.5% x 4,000 = 260. MREL is the higher of the two, 260.
These are examples of how the formulas work. The Pillar 2A of 2% is invented and is not a statement about any bank.
How MREL differs from the capital ratios
CET1, Tier 1 and total capital ratios measure own funds against RWA. MREL counts own funds plus eligible liabilities, debts that can be written down or converted in resolution. The Bank's statement of policy also sets subordination requirements for bail-in institutions (para 4.10, section 6), which we do not summarise. The FPC defines overall regulatory loss absorbing capacity as MREL plus buffers (FPC paper, July 2026, footnote 8). The same paper records that some stakeholders asked for more consistency across CET1, AT1 and Tier 2, MREL and stress test requirements, so that using a buffer in one place does not trigger pressure elsewhere; that is a stakeholder proposal, not a rule. To see where MREL sits next to the other layers, read the capital stack page and Pillar 2A and Pillar 2B.
Not stated
- The MREL of any named bank. The Bank publishes firm-level disclosures, but we did not read them.
- The EU's MREL and TLAC rules (CRR, BRRD, SRB policy). We did not read EU texts for this page.
- The subordination rules, the internal MREL calibration and the full transitional timetable in the statement of policy.
- Which UK firms are currently classed as G-SIBs or D-SIBs for MREL purposes.
Frequently asked questions
What is the difference between MREL and TLAC?
TLAC is the FSB's international standard for global systemically important banks: at least 16% of RWA and 6% of leverage exposure from 2019, rising to 18% and 6.75% from 2022. MREL is the UK requirement set by the Bank of England, and for UK G-SIBs it is the higher of 2 x (Pillar 1 + Pillar 2A), the higher of 2 x the leverage requirement or 6.75% of leverage exposures, and 18% of RWA.
What is MREL for a UK bank that is not a G-SIB?
The Bank of England expects D-SIBs and other UK bail-in resolution entities to meet the higher of 2 x (Pillar 1 + Pillar 2A) and, if subject to a leverage ratio requirement, 2 x that requirement, i.e. 6.5% if the leverage ratio is 3.25% (statement of policy, para 4.11).
Do MREL and capital buffers overlap?
The FSB term sheet says the RWA minimum does not include Basel III buffers, which must be met in addition, and that CET1 used to meet Minimum TLAC must not also be used to meet regulatory capital buffers. For UK treatment, see the Bank's statement of policy and the PRA's supervisory statement on MREL and buffers, which we did not read in full.
What does MREL stand for?
Minimum requirement for own funds and eligible liabilities.
Sources
- Bank of England, Statement of policy: The Bank of England's approach to setting a minimum requirement for own funds and eligible liabilities (MREL), effective from 1 January 2026.
- Financial Stability Board, Principles on Loss-absorbing and Recapitalisation Capacity of G-SIBs in Resolution, Total Loss-absorbing Capacity (TLAC) Term Sheet, 9 November 2015.
- Bank of England, Financial Stability in Focus: The bank capital framework, FPC, July 2026.
Documents read on 19 November 2026.