UK leverage ratio requirement: 3.25% vs the Basel 3% minimum
The Basel minimum leverage ratio is 3% of Tier 1 capital to exposure measure; the UK minimum is 3.25% of the UK leverage exposure measure, which excludes central bank reserves, plus buffers for systemically important banks and a countercyclical leverage buffer. The Bank of England has proposed changes, which the Bank expects to consult on in early 2027.
- Basel leverage ratio
- UK requirements
- Why the UK has a different set-up
- Proposed reforms
- Arithmetic illustration
- Not stated
- Sources
The Basel leverage ratio
The leverage ratio is the capital measure divided by the exposure measure, expressed as a percentage (LEV20.3). The capital measure is Tier 1 capital, meaning CET1 and Additional Tier 1 (LEV20.4). The exposure measure is the sum of on-balance sheet exposures (excluding on-balance sheet derivative and securities financing transaction exposures), derivative exposures, securities financing transaction exposures and off-balance sheet items (LEV20.5). Both are calculated on a quarter-end basis, though banks may use more frequent calculations with supervisory approval if they do so consistently (LEV20.6). Banks must meet a 3% minimum at all times (LEV20.7). The intent is to restrict leverage build-up and to reinforce risk-based capital with a simple non-risk-based backstop (LEV20.1). Our leverage ratio calculator works the formula.
The UK requirements
According to the Bank of England's Financial Policy Committee (FPC), UK leverage ratio requirements comprise:
- a minimum of 3.25% of the UK leverage exposure measure, excluding central bank reserves;
- a systemic buffer, the additional leverage ratio buffer (ALRB), for global systemically important banks (G-SIBs) and certain other systemically important institutions (O-SIIs); and
- the countercyclical leverage buffer (CCLB).
At present the ALRB and the CCLB are applied at 35% of the equivalent risk-based buffers. The Basel standards instead set a single leverage ratio buffer at 50% of systemic risk-weighted buffers for G-SIBs (FPC paper, July 2026). The FPC says the calibration of UK requirements is consistent overall with international standards, but some elements of the UK's implementation differ, including how buffers are set.
Why the UK set-up differs
- The 35% factor was chosen when the framework was introduced to reflect the ratio of the original 3% minimum leverage requirement to the sum of the Tier 1 risk-weighted Pillar 1 minimum (6%) and the capital conservation buffer (2.5%), which is 8.5% (FPC paper, footnote 7).
- After the 2019 decision to raise the neutral UK CCyB rate from 1% to 2%, risk-weighted requirements were adjusted to keep overall loss-absorbing capacity broadly unchanged, but no equivalent adjustment was made in the leverage framework, so leverage requirements rose and the leverage ratio became more likely to bind. The FPC calls this an unintended consequence.
- The FPC says the decline in average UK risk weights has also made leverage ratio requirements more binding.
Proposed reforms (not yet in force)
The FPC's July 2026 paper says the FPC and PRA intend to consult on a package that would:
- remove the CCLB from banks' leverage requirements;
- move the ALRB for firms with systemic buffers to 50% of risk-weighted systemic buffers, in line with international standards, and make it releasable in a stress for domestically systemic firms;
- reduce the Tier 1 minimum leverage requirement from 3.25% to 3%, and apply a general leverage ratio buffer of 25 basis points of the leverage exposure measure, releasable if necessary to zero and met with CET1.
The FPC estimates that, taking into account regulatory requirements and the capital needed to stay above the leverage hurdle rate in the Bank Capital Stress Test, the changes would reduce the leverage ratio that large UK banks subject to the requirement must maintain by around 20 basis points in aggregate, with the impact varying by bank. At its meeting on 25 September 2026 the FPC agreed to proceed with the proposed reforms, which the Bank expects to consult on in early 2027, and said it would consider raising the general leverage ratio buffer above 25 basis points if risks were heightened (FPC record, September 2026, summary section on market leverage). Some members had raised concerns that the proposal could increase market-based leverage, which is why the Committee stressed gilt repo market resilience.
Arithmetic illustration
A hypothetical bank has Tier 1 capital of 60 and a UK leverage exposure measure of 1,800 (excluding central bank reserves). Its leverage ratio is 60 / 1,800 = 3.33%, which is 0.08 percentage points above a 3.25% minimum and 0.33 points above a 3% minimum. These numbers are invented, and they ignore buffers.
Not stated
- The leverage ratio of any named bank, and which banks are subject to the UK requirement.
- The PRA Rulebook text of the UK leverage ratio parts, and the exact thresholds for which firms are in scope.
- The US supplementary leverage ratio and the EU leverage ratio rules. We did not read them for this page, so we do not compare them with the UK.
- The content or date of the consultation beyond the Bank's statement that it expects to consult in early 2027.
Frequently asked questions
What is the UK leverage ratio requirement?
A minimum of 3.25% of the UK leverage exposure measure (excluding central bank reserves), plus an additional leverage ratio buffer for G-SIBs and certain O-SIIs and a countercyclical leverage buffer, both currently applied at 35% of the equivalent risk-based buffers (FPC paper, July 2026).
What is the Basel leverage ratio minimum?
3% of Tier 1 capital to the exposure measure, to be met at all times (LEV20.7).
Is the UK changing its leverage ratio rules?
The FPC and PRA intend to consult on changes, including removing the countercyclical leverage buffer, moving the systemic buffer to 50% of risk-weighted systemic buffers, and cutting the minimum from 3.25% to 3% with a 25 basis point general buffer. In September 2026 the FPC agreed to proceed, and the Bank expects to consult in early 2027. Nothing is in force yet.
What is excluded from the UK leverage exposure measure?
Central bank reserves. The FPC paper describes the measure as one which currently excludes central bank reserves.
Sources
- Basel Framework, LEV20 Definition and minimum requirements (leverage ratio), in force from 1 January 2023.
- Bank of England, Financial Stability in Focus: The bank capital framework, FPC, July 2026.
- Bank of England, Financial Policy Committee Record, September 2026 (meeting of 25 September 2026).
LEV20 text fetched 17 November 2026 and re-read 19 November 2026; the FPC documents read 19 November 2026.