Bank capital buffers: CCB, CCyB and G-SIB explained
Basel III buffers sit on top of the minimum ratios and are met with CET1: a 2.5% capital conservation buffer, a countercyclical buffer of 0% to 2.5% set by national authorities, and a G-SIB surcharge of 1.0% to 3.5% for the largest global banks. The UK countercyclical buffer rate was held at 2% by the Financial Policy Committee on 25 September 2026.
- Capital conservation buffer
- Countercyclical buffer
- G-SIB surcharge
- Adding them up
- UK changes under discussion
- Not stated
- Sources
Capital conservation buffer (CCB)
The Basel Framework sets a capital conservation buffer of 2.5%, made up of CET1, above the regulatory minimum (RBC30.2). When capital falls into this range the bank is subject to capital distribution constraints. The constraints relate to distributions only, not to the operation of the bank (RBC30.2). The table below is RBC30.4: the lower the CET1 ratio, the larger the share of earnings that must be kept.
| CET1 ratio | Minimum capital conservation ratio (share of earnings) |
|---|---|
| 4.5% to 5.125% | 100% |
| Above 5.125% to 5.75% | 80% |
| Above 5.75% to 6.375% | 60% |
| Above 6.375% to 7.0% | 40% |
| Above 7.0% | 0% |
RBC30.4 gives this example: a bank with a CET1 ratio in the range of 5.125% to 5.75% must conserve 80% of its earnings in the next payment period, so it can pay out no more than 20% as dividends, share buybacks and discretionary bonus payments. The CET1 ratio used in the table includes the CET1 used to meet the 4.5% minimum, but excludes any additional CET1 needed to meet the 6% Tier 1 and 8% total capital requirements (RBC30.4).
Countercyclical capital buffer (CCyB)
- Range. The requirement varies between zero and 2.5% of risk-weighted assets, depending on the national authority's judgement of the build-up of system-wide risk (RBC30.9).
- Aim. It is meant to be deployed when excess aggregate credit growth is judged to be associated with a build-up of system-wide risk, so jurisdictions are likely to need it only infrequently (RBC30.7).
- Timing. A jurisdiction pre-announces a decision to raise the buffer by up to 12 months. Decisions to decrease it take effect immediately (RBC30.11).
- Bank-specific rate. An internationally active bank calculates its requirement as a weighted average of the buffers in the jurisdictions where it has private sector credit exposures, weighted by its credit risk charge in each (RBC30.13 and RBC30.14).
- Capital type. Banks must meet it with CET1 or face the distribution restrictions (RBC30.12).
The UK rate
In the UK the Financial Policy Committee (FPC) sets the rate. At its meeting on 25 September 2026 it maintained the UK countercyclical capital buffer rate at its neutral setting of 2% (record, paragraph 26). The FPC's July 2026 paper notes that in 2019 it raised the neutral rate for the UK CCyB from 1% to 2%. We did not read the outcome of any later meeting.
G-SIB higher loss absorbency
Global systemically important banks (G-SIBs) must meet a higher loss absorbency requirement with CET1 only (RBC40.1). G-SIBs are placed in buckets by their score of systemic importance. The cutoff score for G-SIB designation is 130 basis points (RBC40.4), and the requirement for each bucket is:
| Bucket | Score range | Requirement (CET1, % of RWA) |
|---|---|---|
| 5 | 530 to 629 | 3.5% |
| 4 | 430 to 529 | 2.5% |
| 3 | 330 to 429 | 2.0% |
| 2 | 230 to 329 | 1.5% |
| 1 | 130 to 229 | 1.0% |
The top bucket was initially empty (RBC40.4). A G-SIB that moves up a bucket has 12 months to meet the higher requirement (RBC40.6). We do not list which banks sit in which bucket because we did not read the current list.
Adding the layers up: an illustration
For CET1, the buffers described above add to the 4.5% minimum. For a hypothetical bank that meets its Tier 1 and total capital minimums with other capital, with UK-only credit exposures and no G-SIB surcharge:
| Layer | % of RWA |
|---|---|
| CET1 minimum | 4.5% |
| Capital conservation buffer | 2.5% |
| Countercyclical buffer at the UK rate | 2.0% |
| CET1 from these three layers | 9.0% |
Arithmetic only: 4.5 + 2.5 + 2.0 = 9.0. It ignores Pillar 2A, the PRA buffer, any systemic buffer and the rule that CET1 is used first to meet the 6% Tier 1 and 8% total capital minimums. Real requirements are set by the supervisor, see the capital stack page.
UK changes under discussion
The FPC's July 2026 paper says the Committee will work with the PRA towards a single buffer that is releasable in stress and can be used without automatic distribution restrictions. In the near term it says systemic buffers for domestic systemically important banks will be releasable in a stress, and it welcomes the PRA's intention to use its existing discretionary powers to release the O-SII buffer in a systemic stress. The PRA said it will consult on its approach to setting O-SII buffers in the second half of 2026. These are intentions and proposals, not rules in force, and we did not read the consultation.
Not stated
- The CCyB rates of jurisdictions other than the UK.
- The current G-SIB bucket of any bank.
- The Basel Framework version that applies from 1 January 2027 (RBC30 shows a future version effective that date; we read the version in force from 15 December 2019).
- The output of the FPC meeting held after 25 September 2026.
Frequently asked questions
What is the capital conservation buffer?
A buffer of 2.5% of risk-weighted assets, made up of CET1, above the regulatory minimum (RBC30.2). If capital falls into it, the bank faces limits on dividends, share buybacks and discretionary bonuses, not on its business.
What is the countercyclical capital buffer in the UK?
The UK rate is set by the Bank of England's Financial Policy Committee. On 25 September 2026 it kept the rate at its neutral setting of 2%. Basel allows national buffers of 0% to 2.5% (RBC30.9).
What happens if a bank falls into its capital buffer?
Distributions are restricted in line with the table in RBC30.4: for example, a bank with a CET1 ratio of 5.125% to 5.75% must conserve 80% of its earnings. The buffer is meant to be usable, and Basel says banks are expected to fall into the range from time to time (RBC30.3).
What is the G-SIB buffer?
A higher loss absorbency requirement for global systemically important banks, met with CET1 only. It ranges from 1.0% to 3.5% of RWA depending on the bank's bucket (RBC40.4).
Sources
- Basel Framework, RBC30 Buffers above the regulatory minimum (version in force from 15 December 2019).
- Basel Framework, RBC40 Higher loss absorbency requirement (version in force from 15 December 2019).
- Bank of England, Financial Policy Committee Record, September 2026 (meeting of 25 September 2026).
- Bank of England, Financial Stability in Focus: The bank capital framework, FPC, July 2026.
RBC30 text fetched 17 November 2026 and re-read 19 November 2026; RBC40, the FPC record and the FPC paper read 19 November 2026.